Sapphire-audio Snooper Speed camera Manuel d'utilisateur télécharger pdf

9 1087

Charging the internal battery

The Sapphire can be charged using the cigarette lighter adaptor in your vehicle or via the USB

cable connected to your PC. When the unit is turned on the battery charge icon will be animated to

indicate the battery is being charged.

Once fully charged the battery will last approximately 3 hrs during normal use.

Using the cigarette lighter socket

Take the lead and plug the smaller end into the 12V DC input socket on the bottom left hand side of

the Sapphire and plug the cigarette lighter adaptor into your vehicles cigarette lighter socket.

Please Note: Do not leave your Sapphire plugged into the cigarette lighter socket when you

start your vehicle. As it is prone to power surges as the vehicle is started which may damage

your unit.

FOR FURTHER INFORMATION ON INSTALLING AND POWERING YOUR SAPPHIRE PLEASE

REFER TO THE FULL USER MANUAL ON THE CD ROM.

Basic Operating Instructions

1. Using the Sapphire for the first time

After you have performed a download and installed your Sapphire perform the first start up. Make

sure your vehicle is parked in as open a space as possible. The flip-up GPS antenna must have

an unobstructed view of the sky above. Next turn the unit on by pressing and holding the

Standby/Power switch for two seconds. The full colour TFT LCD display will briefly read ‘Snooper’,

Logic #*, Mway*, City* or All* and finally ’Searching for Satellites...’ will flash along the bottom of

the screen as the unit begins to search for satellite connection.

*FOR FURTHER INFORMATION OF THE MODE AND LOGIC SETTINGS PLEASE REFER

TO SECTION 7 AND SECTION 10 OF THE FULL USER MANUAL ON THE CD ROM.

Once the unit has acquired adequate satellite lock it will proceed to the Standby screen of your

choice As soon as the standby screen is displayed your Sapphire is ready to use and will now

automatically alert you of any locations stored in its database. A variety of audible and visual alert

patterns are available. See ‘Features and Settings’ in the full user manual situated on the

CD-ROM for how to further personalise your unit.

As the GPS engine has never been used before, the first ‘Cold’ start could take from

15 – 50 minutes to establish a satellite connection.Ssubsequent start ups should take only

a matter of minutes.Please Note: If the unit is not used for some time the initial GPS start

up may take longer than when the unit is used regularly.

Power Connection & Charging

2. Standby Screen

There are eleven different screen colour settings for the standby display. Please refer to the User

Manual that can be found on the CD Rom to change the screen colour:

3. Adjusting the Volume

The Snooper Sapphire has an adjustable volume for controlling the loudness of the audible alert.

To increase the volume push the ‘OK’ control on the right hand side of the unit upwards. To

decrease the volume of the unit push the ‘OK’ control downwards.

4. Cancelling an Alert

If during an alert you decide that you would like to cancel it simply press and hold either the MEM

or MUTE buttons.

5. Logic Modes

There are three Logic modes that you can select from. These different Logic settings determine

how the Sapphire alerts you to fixed speed safety cameras. Logic 2 is the factory default setting.

When Logic 2 is selected your unit will alert you both audibly and visually as you approach fixed

safety cameras on your side of the carriageway only. For further information on alternative settings

please refer to the user manual.

6. Alert Patterns

Fixed Speed Safety Cameras

As you approach a fixed speed safety camera the unit will begin to emit either a voice alert or your

chosen audible alert at your preset alert distance. As you approach the fixed speed safety camera

the ‘beeping’ will quicken. At the same time the display will indicate the type of location you are

approaching, the speed limit at that location and will then begin to count down the distance in 50

metre increments to that location. The unit will continue to alert you until you have passed the

fixed speed safety camera.

Automute: When your device alerts you to a location, rather than continually beeping through

the alert, it simply beeps at your selected volume for five seconds and then automatically mutes

the sound to volume level 3 until you have passed or moved out of range of the speed camera.

Note: This function is built into the unit and cannot be switched off.

9. Auto Range

Auto-range is selected as the Factory Default setting. In this mode Sapphire simply selects the

correct alert distance to each camera detected depending on the speed limit of the road the

camera is situated on. The different alert distances are shown below.

Speed Limit Pre-Alert

20mph 250m

30mph 300m

40mph 350m

50mph 400m

60mph 700m

70mph 700m

You can also select your own preferred detection distance. For further information please consult

the User Manual on the CD Rom.

10. Road Type - ALL is selected as the factory default setting.

In ‘ALL’ mode the Sapphire will provide alerts on all road types of any fixed speed safety cameras

that are within range of the unit. Note: If you were travelling on a section of motorway for example

it would mean that the unit could detect locations situated on an ‘A’ or ‘B’ road that is near to the

motorway. As it is not on the road you are travelling though, it is not a threat and you might prefer

to select the ‘Mway’ setting so that the unit would ignore these unwanted alerts. For further

information on Road Type settings please consult the User Manual on the CD Rom.

Basic Troubleshooting

The unit cannot be switched on

Check that the cigarette lighter adaptor is well inserted into the cigarette lighter socket and that the

cigarette lighter socket is functioning properly. Check that the lighter socket is clean and free from

debris. Also check that the fuse of the cigarette lighter adaptor is intact.

The unit cannot acquire satellite connection

Check that the Sapphire’s flip up GPS antenna has a clear view of the sky above.

If this is the first time you have powered up your Sapphire please remember that the first ‘cold’ start

may take up to 50 minutes to acquire sufficient satellite connection. Subsequent start up times will

only take a couple of minutes if used regularly.

The satellite signal temporarily or permanently drops out

This may happen temporarily in areas where there are a significant number of tall buildings or trees

or whilst driving through a tunnel. The signal should only be lost for a few seconds and quickly

reacquired.

Check that the device has not moved and that the flip up GPS antenna still has a good clear view of

the sky above.

The device does not appear to respond to fixed speed camera systems

Have you performed a download recently? If not, perform a fresh download to ensure that you have

all the latest coordinates stored on your device.

Check your settings to see if you have ‘Smart Mute’ activated. If ‘Smart Mute’ has been activated the

device will only alert you to GPS generated locations if you are travelling above the posted speed limit.

FURTHER TROUBLESHOOTING INFORMATION CAN BE FOUND IN THE FULL USER

MANUAL SITUATED ON THE CD ROM

Snooper Accessories & Price List

The following accessories are available from your local Snooper dealer. For further details please

visit www.snooperuk.com

External GPS extension antenna……………………………………………......................... £34.99

Coiled power lead with cigarette lighter adaptor……………………….….......................... £12.95

2m Straight power lead with cigarette lighter adaptor………………….……...................... £12.95

2m Straight hard wire lead with fuse…………………………………………....................... £12.95

Windscreen mounting bracket…………………………………………………...................... £24.95

USB PC connection lead………………………………………………................................. £12.95

1 – 3 Lighter socket extension………………………………………………........................... £7.99

25ml anti-static LCD display cleaner & protector……………………………......................... £7.49

Service under Warranty

If your unit requires service within it’s standard 2 year warranty return your Snooper Sapphire, via

special or recorded delivery and in suitable packaging to:

The Returns Department,

Performance Products Limited,

Cleaver House, Sarus Court, Manor Park, Cheshire WA7 1UL

Enclose the following information:

(a) Your name, address and a full description of the problem.

(b) A telephone number where you can be reached during business hours.

Quick Start Guide

GPS Speed Camera Detection System

Sapphire

1 2

Sapphire 1

Résumé du contenu

Page 1 - Sapphire

9 1087Charging the internal batteryThe Sapphire can be charged using the cigarette lighter adaptor in your vehicle or via the USB cable connected to

Page 2

Registering your Sapphire2Features 3Software CD4 5 6IMPORTANT! PLEASE READ BEFORE USING YOUR SAPPHIREThe Sapphire is not pre populated with the Enigma

Commentaires sur ces manuels

Pas de commentaire

Sapphire-audio Snooper Speed camera Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Appareil photos Sapphire-audio Snooper Speed camera. Sapphire Audio Snooper Speed camera User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels